Description:

Machine Body
Charging box with side-walls and mobile hinged lids covered with anti-wear and replaceable steel plates
Liquid collection tank connected to the baler and complete with drain shutter
Guide system of the mobile hinged side-wall.
Hooking system of lid/hammer which mechanically contrasts the box re-opening during the axial compression Hydraulic Power Unit
Integrate in the the machine by flexible pipes suitable to high pressure, and composed of:

• Fluid oil tank with level gauge and temperature gauge
• Fluid oil tank capacity: 800 litres
• Double gear-pumps for both high and low pressure
• Piloting pump
• Oil filtering off line with special circuit
• Motor
• Diesel motor
• Traction Diesel-oil (for Diesel version)

Console inside the control cabin Control and check board placed inside the operator’s cabin, and complete with:
Micro-switch controls on a synoptic board Control panel with signals and luminous spy-lights
Cylinders

• No.1 double-acting axial cylinders (150ton)
• No.4 cylinders on the mobile lateral side-wall (total 180 ton)
• No.4 cylinders on the lid (total 180 ton)
• No.2 cylinders on hammer/lid (90 ton)

• Documentation and material kit
• Electric scheme
• Hydraulic scheme
• Lay-out and installation scheme
• Use and maintenance handbook.

• Column-type Crane
• Two-section with extendable part loading arm
• Lifting capacity: 9.07 metric t.
• Standard extension: 7.11 m
• Hydraulic extension: 1.30 m
• Rotation angle: 407°
• Rotation torque: 1400 kgm

Grab:

• 5-valve model
• Non-stop rotation in both directions
• Volume: 0,25 cu.m.
• Weight: 320 kg

Semi-trailer (tractor unit excluded):

• 2-axle type. The last axle is steering.
• ABS braking system
• Lighting plant
• No.2 mechanic stabilisers
• No.2 hydraulic stabilisers
• Cyclist-protection bars
• Diesel oil tank for the baler
• Length 9500 mm
• Maximum capacity at full load: 22000 kg

Technical Specifications

• Axial thrust: 150 t.
• Minimum bale dimensions: 800 x 500 x 1000 (minimum variable) mm
• Opened charging box: 5000 mm length, 2200 mm width
• idle cycle time: 110 seconds
• Working pressure: 300 bar
• No.2 Groups of double pumps for high and low pressure
• Diesel motor: No.1 Iveco brand water-cooled diesel motor 128HP
• Total weight: 22.000 kg approx.
• Rustproof coat and finishing paint at synthetic enamel and quick drying, RAL 5017
• The machine is manufactured in compliance with EC regulations.

Complete standard version is composed of:

• Complete Baler
• Crane with grab
• Cabin with centralised control